ASTM D3967 PDF
This standard is issued under the fixed designation D ; the number . 1 This test method is under the jurisdiction of ASTM Committee D18 on Soil and. GeoTesting Express is a provider of Rock Testing Services – ASTM D, Standard Test Method for Splitting Tensile Strength of Intact Rock Core Specimens. We propose two compression device models for indirect tensile test (splitting test) conforming to ASTM D and to ISRM Specifications. Model conforming to.
|Published (Last):||5 December 2010|
|PDF File Size:||3.77 Mb|
|ePub File Size:||15.22 Mb|
|Price:||Free* [*Free Regsitration Required]|
In addition, they are representative of the significant digits that generally should be retained.
Also, by testing across different diametrical directions, possible variations in tensile strength for anisotropic rocks can be determined. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Users of this standard are cautioned that compliance with Practice D does not in itself assure reliable ast.
ASTM D – 95a Standard Test Method for Splitting Tensile Strength of Intact Rock Core Specimens
It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Request Quote Client Login. The values given in parentheses are mathematical conversions to inch-pound units, which are provided for information only and are not considered standard.
Under these conditions, tensile strength should be obtained with the presence of compressive stresses as is what occurs in this test to be representative of the field conditions. In rock mechanics design, complicated stress fields are often encountered. The quality of the results produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used.
Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method. This test is a simpler and less expensive alternative to the direct tensile test method. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations.
Since it is widely used in practice, a uniform test method is needed for data to be comparable. The diameter shall be at least 10 times greater than the largest mineral grain constituent. However, the direct tensile test is difficult and expensive for routine application.
For more information, contact: The splitting aztm test appears to offer a desirable alternative, because it is much simpler and inexpensive. Compression testing, indirect tensile strength, loading tests, rock, splitting tensile strength, tension properties, Brazilian tensile strength.
Rock testing Back to Results Print. A uniform test is also needed to make sure that the disk specimens break diametrically due to tensile stresses perpendicular to the loading diameter.
Historical Version s – asym previous versions of standard. Under such conditions, the tensile strength should be obtained with the presence of compressive stresses to be representative of the field conditions. Circular disk with a thickness-to-diameter ratio between 0.
Active Risk Management
For Individuals with needing special assistance for disabilities or limited English proficiency Please contact our Title VI specialist at This test determines the splitting tensile strength of rock by diametral line compression of a disk of rock. Rock testing Lab Services: Link to Active This link will always route to the current Active version of the standard.
Furthermore, engineers involved in rock mechanics design usually deal with complicated stress fields, including various combinations of compressive and tensile stress fields.
Enough samples to represent a valid average of the type of rock under consideration; however the standard recommends Reliable results depend on many factors; Practice D provides a means of evaluating some of those factors.
These include combinations of compressive and tensile stress fields.